Bosch error code E262: The door locking mechanism did not move to the required position during the self-clean cycle startup or at the end of the cycle. The oven cannot start or complete the self-clean program.
The door locking mechanism did not move to the required position during the self-clean cycle startup or at the end of the cycle. The oven cannot start or complete the self-clean program.
The door lock mechanism is temperature-sensitive. If the oven is hot, the lock may not release until it cools below a threshold (usually 300°F / 150°C). Wait at least 30 minutes after the oven cools before attempting to open.
Unplug the oven or flip its breaker for 60 seconds. This resets the control board and may release a stuck lock command.
Some ovens have a manual door lock release inside the storage drawer or broiler compartment — a spring-loaded lever that bypasses the motor. Consult your model's service manual. Do not force the door open.
Disconnect power. Access the lock motor (usually along the top edge of the door, behind the back panel or accessible from inside the control area). Check the motor for continuity and confirm the lock arm moves freely by hand.
Tools needed: Multimeter, Screwdriver set, Gloves
The lock assembly has one or more microswitches that tell the board when the lock is open or closed. Test each for correct continuity in both the locked and unlocked positions.
Tools needed: Multimeter
Order the OEM door lock motor and switch assembly. It typically mounts with 2–4 screws along the door frame top edge and connects via a 3–5 wire harness.
Tools needed: Screwdriver set