GE Appliances error code E1: The motor control system detected an abnormal condition. The machine stops to prevent motor damage.
The motor control system detected an abnormal condition. The machine stops to prevent motor damage.
An overloaded drum forces the motor to work beyond its rated torque. Remove half the items and try running the cycle again. The motor should reach speed within seconds of starting.
Rotate the drum by hand (with power off). It should turn smoothly with a little resistance. If it grinds, catches, or won't turn, something may be lodged between the drum and the outer tub — a coin, underwire, or debris.
On direct-drive machines skip this step. On belt-drive machines, a broken or slipped belt will prevent the drum from spinning. Access the motor compartment and check the belt for cracks, fraying, or misalignment.
Tools needed: Screwdriver set
If the motor overheated, a thermal cutout may have tripped. Allow the machine to cool for 30 minutes, then retry. If the motor ran hot due to repeated overload, the thermal protector may eventually fail permanently.
Disconnect power. Locate the motor control board (separate from the main board on many front-loaders). Inspect for burn marks or swollen capacitors. Test the input voltage and output to the motor with a multimeter.
Tools needed: Multimeter, Screwdriver set
With power disconnected, remove the motor. Test continuity between each winding terminal. An open winding means the motor is burned out and requires replacement.
Tools needed: Multimeter